VNC2 DEBUG MODULE

The VNC2 DEBUG MODULE is a VNC2 debugger/programmer module. It is designed to provide connectivity between the Vinculum-II IDE development software and the debug interface pin on the Vinculum-II (VNC2) USB host controller device. The VNC2 debug module consists of a miniature board with a USB mini B connector, which provides USB connectivity to Vinculum-II IDE development tools running on a PC. This module can be used to program and debug firmware running on the VNC2 device. The module connects to the VNC2 device via a 6 way, 2mm pitch, keyed, female connector. The V2DIPx-x, VNC2 based development modules are equipped with a compatible male connector to host the VNC2 debug module. Designers intending to use the module with their own VNC2 based hardware are required to have a similar compatible male connector on their hardware.

• One USB mini B type socket to connect with a PC
• On board FTDI FT232R which provides conversion from USB to serial interface for VNC2 debug port
• Low USB bandwidth consumption
• USB 2.0 full speed compatible
• UHCI/OHCI /EHCI host controller compatible
• 5V power output to V2DIP-x module (if needed)
• USB powered
• Programming and debugging for VNC2 IC designs
• Power and traffic indicator LEDs
• 6 way, keyed connector to support V2DIPx-x development modules

Aplicaţii

Embedded Design & Development

Avertismente

Market demand for this product has caused an extension in leadtimes. Delivery dates may fluctuate. Product exempt from discounts.